About me: i like to cook. i dont like to clean...
too sarcastic for my own good
aim - medoch312
NOT written by me:
When your working on a
project;
And you're brain is full to top;
And the tool steel sits;
On the workbench in the shop;
While the spheroidizing normalizer quantifies the quench;
And the over-tightened cap screw cams out from the wrench;
Remember for the moment your S sub X depends;
For there IS no moment at the very end.
You say that my ramblings;
Are over swayed to theory?
Let's look at an example;
Which is practical, most nearly.
If the tool steel cracks for its temper was not drawn;
Don't blame the furnace that sits out on the lawn.
Just remember that in earnest you burned it way too strong;
And a LITTLE extra furnace will render tempers drawn.
For the temper ampere damper, the thermostatic spawn;
Was set much too loosely in the furnace on the lawn.
When the temper ampere damper clamper is set good and strong;
You may forget about the metal in the furnace on the lawn.
So go back, back to the bench!
With the over-tightened cap screw;
Cammed out from the wrench.
And recall, there is something to be used in such a pinch;
The Chinese extractor set;
Point one-two-five through one-half inch!
Pilot drill and lever;
With left-hand binding pitch;
The cap screw is removed;
Just like that!
A real cinch.
........................
Who I'd like to meet: rossi, KR Jr, hakkinen, Senna (RIP), Dean (RIP)
wow thats really late in the year! i'd love to but my s2000 is in storage, i'm doing some long term projects on the 240, and the 4runner is not very nimble! next year...
